光纤复合型油气井下压力温度测量系统

针对目前广泛使用的电子式油气井下压力温度测量系统可靠性低、高温环境漂移大的不足,设计了一种基于非本征型F-P干涉仪(EFPI)和光纤布喇格光栅(FBG)的复合型油气井下压力、温度测量系统,详细说明了其工作原理、传感器组成和信号解调方法,初步试验结果表明,该测量系统不仅克服了电子测量方式的不足,而且具有复用性好、测量精度高等优点.     

A NOVEL EOR POLYMER (Ⅱ)——INVESTIGATION ON IN-SITU GELATION OF SMRF SYSTEM IN BEREA CORE

In-situ gelation of aqueous sulfomethylated resorcinol formaldehyde (SMRF) system inBerea core has been investigated. Two sets of displacement experiments were conducted with thissystem (containing 5% NaCl, 0. 036% CaCl_2. 2H_2O). The brine permeabilities of the coreswere reduced significantly from about 600 to 0.1 md. The in-situ gelation in Berea core occurreda little bit earlier than gelation anticipated from bulk test in the experiments. The gel time waseasier to control at initial pH between 6 and 8. During injection of SMRF system, the apparentviscosity was less than 1 mPa·s at 41℃.     

Kinetics of oil saponification by lead salts in ancient preparations of pharmaceutical lead plasters and painting lead mediums

Lead soaps can be found in archaeological cosmetics as well as in oil paintings, as product of interactions of lead salts with oil. In this context, a better understanding of the formation of lead soaps allows a follow-up of the historical evolution of preparation recipes and provides new insights into conservation conditions. First, ancient recipes of both pharmaceutical lead plasters and painting lead mediums, mixtures of oil and lead salts, were reconstructed. The ester saponification by lead salts is determined by the preparation parameters which were quantified by FT-IR spectrometry. In particular, ATR/FT-IR spectrometer was calibrated by the standard addition method to quantitatively follow the kinetics of this reaction. The influence of different parameters such as temperature, presence of water and choice of lead salts was assessed: the saponification is clearly accelerated by water and heating. This analysis provides chemical explanations to the historical evolution of cosmetic and painting preparation recipes.     

破乳剂对油水界面膜作用机理研究

研究了破乳剂存在下油膜寿命、油膜薄化速率以及油水界面性质与破乳效果的关系.结果表明,破乳剂使油水界面弹性降低,导致油水界面强度减弱,界面膜寿命变短,界面膜厚度变薄.当膜厚度变薄到一临界值时,膜破裂,导致破乳脱水.同种破乳剂,随着其浓度的增加,界面弹性降低.当浓度超过某一值时,界面弹性值基本不变.不同种破乳剂,界面弹性降低幅度越大,其破乳效果越好.界面弹性值可以很好解释破乳剂的脱水率变化规律.     

油溶性偶氮染料的合成及其性能研究

随着染料在现代科技中的广泛应用,染料的油溶性也日益受到人们的重视.如:非线性光学材料、激光盘光学信息存贮材料中使用的染料、彩色成像中的油溶性影像染料等,对染料在有机溶剂中的溶解度都有很高的要求.偶氮染料是有机染料中的主要类型,但目前对其分子结构与油溶性关系的研究甚少.本文合成了一类黄色偶氮染料(见表1),并对其色光、油溶性等性能进行了测试,发现取代基相对于偶氮基的位置,是影响偶氮染料油溶性的主要因素.     

灰化消解-极谱法测定油料中五个重金属元素

建立了灰化消解-极谱法测定油样中镉、铅、铜、镍、钴等5种微量重金属元素的含量.油料样品通过灰化法消解后,用极谱法在乙酸-乙酸盐缓冲溶液和磺基水杨酸-磷酸-氨水体系中测定5种重金属元素的含量.5种微量重金属元素的检出限为1.3×10-4～9.8×10-4 g·L-1,加标回收率为90%～106%,相对标准偏差为0.22%～3.16%.     

Semi-micro solvent extraction as a rapid and efficient preconcentration technique for the determination of n-alkanes in oil-contaiminated water and soil samples by capillary gas chromatography

Summary In this study, a rapid and efficient semi-micro extraction procedure is presented for the extraction of some higher n-alkanes from water and soil samples. In the case of water samples n-hexane was used as the organic phase in a phase volume ratio (volume of aqueous phase/volume of organic phase) higher than 285, while in the case of soil samples, extraction with n-hexane was carried out in the presence of an excess of 2 M NaCl solution. The extraction rate from soil samples is very high and is better than Soxhlet extraction, comparable with supercritical fluid extraction. High preconcentration factor in water samples allows the limits of detection to be in the ng.mL⁻¹ level with the use of gas chromatographic analysis. Flame ionization detector was used for monitoring the analytes. The obtained recoveries of all studied compounds from both water and soil samples are higher than 90%. This method was successfully used to determine some n-alkanes in municipal wastewater and contaminated soil.     

Shape analysis based critical Eotvos numbers for buoyancy induced partial detachment of oil drops from hydrophilic surfaces

Removal of oil drops from solid surfaces immersed in an aqueous medium is of interest in many applications. It has been shown that drop shape analysis can be used to predict conditions at which the stability limit of a lighter than water oil drop on a solid surface immersed in an aqueous bath is reached (Adv. Colloid Interface Sci. 98 (2002) 265). However the above analysis is restricted to cases where the contact angle made by the drop is below 90degrees and when the surface conditions result in a 'pinned' contact line. In this paper, it is shown that drop shape analysis can be used to predict the critical conditions at which drop stability limit is reached for drop contact angles of 90degrees and above, which is encountered with 'hydrophilic' surfaces. This critical condition can predict the occurrence of partial oil drop detachment, before complete removal due to 'roll-up', which occurs when the hydrophilic surface is adequately smooth which prevents 'pinning' of the contact line. The critical conditions at which partial drop detachment occurs can also be approximately predicted from simple force balances. It has been shown (Adv. Colloid Interface Sci. 98 (2002) 265) that for contact angles less than 90degrees, the critical limit based on shape analysis appears to resolve the differences that arise due to alternate expressions for capillary retention force. This paper shows that even for contact angles above 90degrees, the critical conditions predicted from the shape analysis resolves the differences in the predictions from the alternate force balances. Drop shape analysis used in this paper is based on the 'Arc-length' form of Young-Laplace or 'drop shape' equation, which is different from the 'Y vs X' form of the above equation that is used in Adv. Colloid Interface Sci. 98 (2002) 265. The above drop shape equation is solved by a fourth order Runge-Kutta technique and it is shown that for angles less than 90degrees, the two forms of the drop shape equation, predict almost identical values of the critical Eotvos number. This paper highlights the competing effects of interfacial tension lowering induced drop instability and 'roll-up', a term that is used to describe the retraction of the contact line of an oil drop on a surface, in being the primary c ause for drop detachment.     

X—射线荧光光谱法分析燃油锅炉受热面的灰渣成分

用X-射线荧光光谱(XRF)法测定了火电厂燃油锅炉受热面的灰渣成分,给出了XRF测试条件,与等离子体发射光谱法的测试结果进行了对比。     

眼镜蛇蛇油中甘油三酸酯的成分研究

用ＡｇＮＯ３－硅胶薄层板，氯仿＋丙酮（２０＋１）为展开剂，将蛇油中甘油三酸酯分离为５个组分，并用同样的色谱固定相和石油醚－氯仿－丙酮溶剂系统进行制备性分离。用质谱法对甘油三酸酯进行分子一级水平的化学研究，确定了眼镜蛇蛇油中５个主要的甘油三酸酯成分的结构形式为：１６∶０－１８∶０－１８∶０，１６∶０－１８∶０－１８∶１，１６∶０－１８∶２－１８∶１，１８∶２－１８∶２－１８∶０，１８∶２－１８∶２－１８∶１。